Hi all!
So we've been encountering some difficulties with building HP 845 G9's via PXE. The same DP is able to build all our other devices (HP G6-G8) with no issues at all, and all other DP's are able to build 840 G9's, however with the G9 845, after the initial PXE boot loads WinPE with our custom image, it hangs for roughly 30 seconds and then the device restarts.
I have attached the SMSTS.log below, but the main error that keeps appearing is this:
I have tried creating a new boot.WIM and injected almost all the drivers supplied by HP here:https://ftp.ext.hp.com/pub/caps-softpaq/cmit/softpaq/WinPE10.html, along with adding the driver directly from the 845 driver pack and connected this to a new test task sequence, with the same results. I have also tried the following:
Many thanks
So we've been encountering some difficulties with building HP 845 G9's via PXE. The same DP is able to build all our other devices (HP G6-G8) with no issues at all, and all other DP's are able to build 840 G9's, however with the G9 845, after the initial PXE boot loads WinPE with our custom image, it hangs for roughly 30 seconds and then the device restarts.
I have attached the SMSTS.log below, but the main error that keeps appearing is this:
I have tried creating a new boot.WIM and injected almost all the drivers supplied by HP here:https://ftp.ext.hp.com/pub/caps-softpaq/cmit/softpaq/WinPE10.html, along with adding the driver directly from the 845 driver pack and connected this to a new test task sequence, with the same results. I have also tried the following:
- Fast boot disabled in BIOS
- Name added to Asset tag on devices in BIOS to match SCCM
- Clock set to local time in BIOS
- Tried Secure boot OFF & ON
- Tried a different dock / ethernet connection
- Tried Enable PXE Responder without WDS on SCCM DP (//www.photo-critics.com/enable-pxe-responder-without-wds-on-sccm-dp/)
- Used Secure Erase on the device in the BIOS (not all devices, just 1 to test)
- I have also found the following:https://forums.prajwaldesai.com/thr...vm-has-ip-address-but-cant-ping-gateway.2726/however no patching has been done that would cause this problem
- Using a working device on the docking station, I am able to ping the DP without issue
Many thanks
